Totalpris:  0,00 DKK

Vis kurv

Icom IC-7200

Icom IC-7200

Del med dine venner


Bedømmelse af Icom IC-7200
Produktet er endnu ikke bedømt
Vare nr.  17200

Du skal være oprettet som kunde - og logget ind - for at kunne se vores priser! Du ansøger om login via menuen herover

- AGC loop management
- Digital IF filter
- Digital Twin PBT
Simple & Tough with IF DSP

The latest IF DSP technology is employed in the IC-7200. While the IC-7200 is an entry-class transceiver, advanced digital features are comparable to higher class transceivers.

AGC loop management
Distortion and blocking from strong nearby signals are prevented by placing DSP functions inside the AGC loop. The AGC time constants are selectable from fast, slow and off for each operating mode.

Digital IF filter
Optional filters will be never required for the IC-7200. The built-in digital filter allows you to flexibly select the filter width and shape from soft and sharp* and provides cuttingedge filter characteristics.
* Filter shape is selectable for SSB and CW modes only.

Digital Twin PBT
Only Icom brings you Twin Passband tuning! Tailor your IF passband with the Twin PBT by electronically shifting the upper and lower edges of the IF filter. Depending on the use of the concentric knobs, you can either narrow the IF passband, or shift the entire passband to eliminate interfering signals.

Manual notch filter
The manual notch filter delivers more than 70dB of attenuation. Strong interfering tones will be eliminated without adversely affecting the AGC loop performance. On the bottom right of the front panel, a dedicated control knob adjusts the notch filter frequency.

Digital noise reduction
Digital noise reduction reduces background noise and improves the signal-to-noise ratio. The noise reduction level is adjustable in 16 steps. It improves the readability of voice and data signals.

Digital noise blanker
The noise blanker reduces pulse-type noise such as engine ignition and sparking. The NB level and width (blanking duration) are adjustable in 100 steps.

High stability transmitter
The DDS (Direct digital synthesizer) creates a clear, clean transmit signal and improves the C/N ratio. With a dual-fan cooling system, the IC-7200 provides stable high quality output even during high duty cycle operation.

USB port for PC control
The IC-7200 can be controlled by a PC through a USB port using the CI-V data format. In addition, modulator and received audio can also be transferred over the USB cable. By using appropriate external software, you can record incoming call and/or transmit preprogrammed messages from your PC.

RF speech compressor
The digital RF speech compressor increases your average talk power in SSB mode. Even when the compression level is increased, the DSP controlled RF speech compressor provides low distortion audio.

CW mode operation
Full break-in, selectable CW carrier point (USB or LSB) and adjustable CW pitch are also standard.

Tough construction against water intrusion
Waterproof protection technologies that are used in Icom’ s marine radios are applied to the buttons and knobs on the front panel to provide a measure of protection against water intrusion.*IC-7200 is NOT waterproof.

Rugged design for outdoor use
The rugged design of the IC-7200 means your enjoyment of this rig is not limited to your shack only.



Frequency coverage*1
(Differs according to version)
Rx :

Tx :
1.800– 1.999999MHz 3.500– 3.999999MHz
5.255– 5.405MHz*3 7.000– 7.300MHz
10.100–10.150MHz 14.000–14.350MHz
18.068–18.168MHz 21.000–21.450MHz
24.890–24.990MHz 28.000–29.700MHz
Frequency stability Less than ±0.5ppm
Maximum current drain 22.0A
Power supply requirement 13.8V DC ±15 % (negative ground)
Antenna connector SO-239 (50Ω)
Number of memory
201ch (199 regular, 2 scan edges)
(W×H×D; Projections
are not included)
241×84×281 mm
9.49×3.31×11.06 in
Weight (approx.) 5.5 kg; 12.1 lb
*1 Shows USA version. Frequency coverage depends on version.
*2 Guaranteed range: 0.5-29.999 and 50-54.000 MHz.
*3 Some frequency ranges are not guaranteed.


Output power

2–100 W

1–25 W

Spurious emissions Less than –50dB (HF)
Less than –63dB (50MHz)
Carrier suppression More than 50dB
Unwanted sideband More than 50dB
Microphone connector 8-pin connector (600Ω)


(10dB S/N, Preamp ON, Filter shape sharp)
Less than 0.16μV (1.8–29.995MHz):
Less than 0.13μV (50MHz band)

Less than 13μV (0.5–1.8MHz)
Less than 2μV (1.8–29.995MHz)
Less than 1μV (50MHz band)
Selectivity SSB(BW: 2.4kHz, sharp):
More than 2.4kHz/–6dB
Less than 3.6kHz/–60dB

CW(BW: 500Hz, sharp) :
More than 500Hz/–6dB
Less than 900Hz/–60dB

RTTY (BW: 350Hz):
More than 360Hz/–6dB
Less than 650Hz/–60dB

AM (BW: 6kHz):
More than 6.0kHz/–6dB
Less than 15.0kHz/–60dB
Spurious and image
More than 70dB
(Except 12 IF through on 50MHz band)
AF power
(at 10% distortion with an 8Ω load)
More than 2.0W
External speaker
2-conductor 3.5 (d) mm (18″) /8Ω

All stated specifications are subject to change without notice or obligation.